Reply to thread

Message

<blockquote data-quote="seedubau" data-source="post: 6706903" data-attributes="member: 619791">So Im building my first system other than a couple head unit installs and speaker replacements. I&#039;ve got an Alpine CDE-9841 which I hope to replace when more money comes in.What I have so far:2x 5 1/4&quot; three way (rated at 200W and 4ohm impedance)2x 6&quot;x9&quot; three way (300W 4ohm impedance)2x Super Titanium Tweeters 3 1/4&quot; (300W 4-8ohm impedance)My amp is a Jensen 400 Watt 4 channel (Bridgable)50 watts RMS x 4 channels at 4 ohms83 watts RMS x 4 channels at 2 ohms150 watts RMS x 2 channels bridged at 4 ohmsand it says its stable in 2 ohm when wired into stereoRight now I&#039;m trying to figure out the best way to set up my system (ie parallel/series/combo) to get the best sound without frying the amp.What are you suggestions on how to run this setup?</blockquote>

[QUOTE="seedubau, post: 6706903, member: 619791"] So Im building my first system other than a couple head unit installs and speaker replacements. I've got an Alpine CDE-9841 which I hope to replace when more money comes in. What I have so far: 2x 5 1/4" three way (rated at 200W and 4ohm impedance) 2x 6"x9" three way (300W 4ohm impedance) 2x Super Titanium Tweeters 3 1/4" (300W 4-8ohm impedance) My amp is a Jensen 400 Watt 4 channel (Bridgable) 50 watts RMS x 4 channels at 4 ohms 83 watts RMS x 4 channels at 2 ohms 150 watts RMS x 2 channels bridged at 4 ohms and it says its stable in 2 ohm when wired into stereo Right now I'm trying to figure out the best way to set up my system (ie parallel/series/combo) to get the best sound without frying the amp. What are you suggestions on how to run this setup? [/QUOTE]

Verification