Reply to thread

Message

<blockquote data-quote="Torrey" data-source="post: 7423368" data-attributes="member: 635203">Ok so I have an 84 El Camino with a sony //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif in dash deck installed. I am upgrading my audio system to a Rocksford mono channel amp with 300w rms running a Boston Acoustics 12&quot; G2 300w rms sub. I am also putting a RF 2 channel amp (2x50w @ 4ohm) in to power my 6x9s. i have yet to buy anything besides the 6x9s so do you recommend me getting a more powerful 2 channel amp and bridging it to run the sub and the 6x9s without the mono sub amp?. i also am running 3 1/2&quot; off the deck. anyways if i get the two amps how exactly should i wire this? should it be like the following diagram?[battery]--fuse holder-----[dist block]--amp1 and 2(fused)I am going to use 4gauge power from the battery to the dist block and split to two 8 guages. The 8 guages should be able to run enough juice to my mono amp correct?. i dont need any speaker wire from the deck to the amps just rca cables? please offer any advice you have as this is my first personally done install. and should i just get one 2 channel amp instead of 2 separate amps? Thanks</blockquote>

[QUOTE="Torrey, post: 7423368, member: 635203"] Ok so I have an 84 El Camino with a sony [IMG]//content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif[/IMG] in dash deck installed. I am upgrading my audio system to a Rocksford mono channel amp with 300w rms running a Boston Acoustics 12" G2 300w rms sub. I am also putting a RF 2 channel amp (2x50w @ 4ohm) in to power my 6x9s. i have yet to buy anything besides the 6x9s so do you recommend me getting a more powerful 2 channel amp and bridging it to run the sub and the 6x9s without the mono sub amp?. i also am running 3 1/2" off the deck. anyways if i get the two amps how exactly should i wire this? should it be like the following diagram? [battery]--fuse holder-----[dist block]--amp1 and 2 (fused) I am going to use 4gauge power from the battery to the dist block and split to two 8 guages. The 8 guages should be able to run enough juice to my mono amp correct?. i dont need any speaker wire from the deck to the amps just rca cables? please offer any advice you have as this is my first personally done install. and should i just get one 2 channel amp instead of 2 separate amps? Thanks [/QUOTE]

Verification