Reply to thread

Message

<blockquote data-quote="JoshC" data-source="post: 7472308" data-attributes="member: 634938">Had my box redone today down to 1.25cu net at 35Hz, its a simple port with one board, air goes out the bottom of a wedge box. Was having problems gettin the box to respond the first time it was built, was large and tuned very low. Made it recommend size for decent bass to most music. Im not hearing this kind of flapping noise, kinda like theres a piece of paper by the port being blown my the port. Theres nothing in the port and its not blowing on somthing. The noise isnt really coming from the sub side so i dont think its the sub but idk. When i put my ear by it dosnt sound like thats where its coming from. Anything u can think of that could cause this?Its a jbl power 10, dual 2 hooked up at 1ohm to a audiopipe ASPM1300, gain is at half. I really dont think im overpowering it, ive heard of people putting 800rms to these daily, i think 600 is what it wants honestly. Im about to change it since i have 2 outputs, run 2 sets of wires 1 to each voice coil.</blockquote>

[QUOTE="JoshC, post: 7472308, member: 634938"] Had my box redone today down to 1.25cu net at 35Hz, its a simple port with one board, air goes out the bottom of a wedge box. Was having problems gettin the box to respond the first time it was built, was large and tuned very low. Made it recommend size for decent bass to most music. Im not hearing this kind of flapping noise, kinda like theres a piece of paper by the port being blown my the port. Theres nothing in the port and its not blowing on somthing. The noise isnt really coming from the sub side so i dont think its the sub but idk. When i put my ear by it dosnt sound like thats where its coming from. Anything u can think of that could cause this? Its a jbl power 10, dual 2 hooked up at 1ohm to a audiopipe ASPM1300, gain is at half. I really dont think im overpowering it, ive heard of people putting 800rms to these daily, i think 600 is what it wants honestly. Im about to change it since i have 2 outputs, run 2 sets of wires 1 to each voice coil. [/QUOTE]

Verification