Reply to thread

Message

<blockquote data-quote="greenpat01" data-source="post: 8135754" data-attributes="member: 648035">Hey guys , just finish my installation of my sub which is :Hdc3 12 D2Aq1200dO gauge all aroundBig 3 done in 0 gauge8 gauge speaker wirecustom box : 2.5 cubes @ 34 hz, 15.525 in^2 per cubetop/bottom:&nbsp; (2)&nbsp; 18 x 30sides:&nbsp; (2)&nbsp; 13.5 x 18fronts:&nbsp; (2)&nbsp; 13.5 x 25.625rear:&nbsp; 28.5 x 13.5port wall 1:&nbsp; 13.5 x 12.875port wall 2:&nbsp; 13.5 x 11.625the problem is : I wired it to 1 ohm , setting the amp with the smd DD-1 , all my ground are good and at full tilt im not really satisfied about it ... dose not&nbsp; it hard at all ... just want to know why ?if I put a sheet of paper in front of the port she only making Small wave ..and with only a 70 amp alt (civic) my voltage wont drop below 13.5 on full tilt IDLE... normal on 1200 rms ?Thanks .. sorry if my English is not that good but ...</blockquote>

[QUOTE="greenpat01, post: 8135754, member: 648035"] Hey guys , just finish my installation of my sub which is : Hdc3 12 D2 Aq1200d O gauge all around Big 3 done in 0 gauge 8 gauge speaker wire custom box : 2.5 cubes @ 34 hz, 15.525 in^2 per cube top/bottom: (2) 18 x 30 sides: (2) 13.5 x 18 fronts: (2) 13.5 x 25.625 rear: 28.5 x 13.5 port wall 1: 13.5 x 12.875 port wall 2: 13.5 x 11.625 the problem is : I wired it to 1 ohm , setting the amp with the smd DD-1 , all my ground are good and at full tilt im not really satisfied about it ... dose not it hard at all ... just want to know why ? if I put a sheet of paper in front of the port she only making Small wave .. and with only a 70 amp alt (civic) my voltage wont drop below 13.5 on full tilt IDLE... normal on 1200 rms ? Thanks .. sorry if my English is not that good but ... [/QUOTE]

Verification