Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Half blown 800a2 vs. PRS-D1100M
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="wannabegt4" data-source="post: 4060588" data-attributes="member: 586243"><p>I have a half blown RF 800a2 running a Pioneer TS-W306C SVC 4 Ohm sub rated at 400 watts RMS. I understand the old RF amps like I have are rated well below their actual output power but I wasn't sure if that applied when I'm only running on one channel.</p><p></p><p>From the specs I've seen the 800a2 is rated at 200-240 watts RMS per channel at 4 ohms depending on supply voltage. Will the Pioneer PRS-D1100M rated at 400 watts RMS at 4 Ohms really make that much of a difference?</p></blockquote><p></p>
[QUOTE="wannabegt4, post: 4060588, member: 586243"] I have a half blown RF 800a2 running a Pioneer TS-W306C SVC 4 Ohm sub rated at 400 watts RMS. I understand the old RF amps like I have are rated well below their actual output power but I wasn't sure if that applied when I'm only running on one channel. From the specs I've seen the 800a2 is rated at 200-240 watts RMS per channel at 4 ohms depending on supply voltage. Will the Pioneer PRS-D1100M rated at 400 watts RMS at 4 Ohms really make that much of a difference? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Half blown 800a2 vs. PRS-D1100M
Top
Menu
What's new
Forum list
