Reply to thread

Message

<blockquote data-quote="Speedbump3" data-source="post: 4650503" data-attributes="member: 593347">I know they take 3ohm and I never ran 2ohm long enough to fry any of mine, because I SEEN them fry. The ones I hooked to a 2ohm load permanently were done out of request for the people I was installing them for despite my warnings. So I didn&#039;t fry them. They were fried by idiot owners who thought they knew more because they listened to idiots spew BS like you.If you honestly think these amps are that capable, then clamp it and make a video showing me all these things. You will need a klippel distortion analyzer too.A. It is pushing a 600RMS sine wave @ 1ohmB. There isn&#039;t overly abundant distortionC. It last more than 30 minutes at this leveluntil you can show this, your seat of the pants claim of it making 600RMS @ 1 ohm is PURE BS.Call up a tech at Landis and kindly ask them how many boards they have seen come in unrepairable due to someone running 2 ohms and under bridged. The Power supplies in these get so hot they burn the board into an unrepairable state.This was never an exercise in trolling. It was an exercise in keeping people from doing a stupid maneuver like you claim to do. It&#039;s people like you that make the respectable RF fans look bad.</blockquote>

[QUOTE="Speedbump3, post: 4650503, member: 593347"] I know they take 3ohm and I never ran 2ohm long enough to fry any of mine, because I SEEN them fry. The ones I hooked to a 2ohm load permanently were done out of request for the people I was installing them for despite my warnings. So I didn't fry them. They were fried by idiot owners who thought they knew more because they listened to idiots spew BS like you. If you honestly think these amps are that capable, then clamp it and make a video showing me all these things. You will need a klippel distortion analyzer too. A. It is pushing a 600RMS sine wave @ 1ohm B. There isn't overly abundant distortion C. It last more than 30 minutes at this level until you can show this, your seat of the pants claim of it making 600RMS @ 1 ohm is PURE BS. Call up a tech at Landis and kindly ask them how many boards they have seen come in unrepairable due to someone running 2 ohms and under bridged. The Power supplies in these get so hot they burn the board into an unrepairable state. This was never an exercise in trolling. It was an exercise in keeping people from doing a stupid maneuver like you claim to do. It's people like you that make the respectable RF fans look bad. [/QUOTE]

Verification