Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Gain for lower RMS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="soulstace" data-source="post: 1934194" data-attributes="member: 569136"><p>Yes, you could run that sub on that amp just fine. Just be careful. If it's a dual 4 ohm sub, and you connect the voice coils in parallel, it will be running at 2 ohms and the amp would allow 500rms to be pushed to it. The good news is you will get clean bass with little to no distortion. If you turn it up too loud the voice coil will most likely bottom out and you'll hear a loud clipping sound (I heard this sound before, when I hooked up my two 300 Watt rms 10w3 to the 1200W+ RMS amplifier in my avatar. It didn't actually damage the speakers). Just keep the gain below the threshold. If you start to hear clipping from the speaker turn it down fast!</p><p></p><p>I think having too little power for the sub is worse than having more power than it was meant to handle! Too little power will lead into much more distortion when you crank it up louder. And in my experience distortion leads to more blown subs than anything else.</p></blockquote><p></p>
[QUOTE="soulstace, post: 1934194, member: 569136"] Yes, you could run that sub on that amp just fine. Just be careful. If it's a dual 4 ohm sub, and you connect the voice coils in parallel, it will be running at 2 ohms and the amp would allow 500rms to be pushed to it. The good news is you will get clean bass with little to no distortion. If you turn it up too loud the voice coil will most likely bottom out and you'll hear a loud clipping sound (I heard this sound before, when I hooked up my two 300 Watt rms 10w3 to the 1200W+ RMS amplifier in my avatar. It didn't actually damage the speakers). Just keep the gain below the threshold. If you start to hear clipping from the speaker turn it down fast! I think having too little power for the sub is worse than having more power than it was meant to handle! Too little power will lead into much more distortion when you crank it up louder. And in my experience distortion leads to more blown subs than anything else. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Gain for lower RMS
Top
Menu
What's new
Forum list