Reply to thread

Message: <blockquote data-quote="Cashdollar2009" data-source="post: 6884952" data-attributes="member: 617476"><p>Quick question, I am putting two runs of 2/0 from my front battery to my rear battery bank. I understand the placement of the fusing along each line, but was curious as to the size. I am planning to run a Crescendo 3k @ 1-ohm for 3000rms. The fuseholders shipped with 150 amp anl fuses. Would it be proper to just run 150 amp fuses in each holder on each line? I understand if I were trying to squeeze 3k out of one run of wire it would be drawing too much current theoretically, but could I divide the load out between the runs? Thanks ahead!</p></blockquote><p></p>

Top