Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: Phoenix Gold MPS-2500
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="JayGold" data-source="post: 7004258" data-attributes="member: 583606"><p>So up for grabs is a very nice MPS-2500.</p><p></p><p>Modified by Phoenix Gold to reflect the most current circuit board wiring as the TA (Team Amp) series.</p><p></p><p>Cosmetics: 7.5/10.0 mainly rated due to the slight chipped coating on the end caps and cover which may be easily replaced if you can find them. The heat sink chassis is about a 9.0/10.0...still very glossy.</p><p></p><p>Performance: Tested and operating fine, no signs of caps leaking but they will need to be replaced as a caution.</p><p></p><p>Asking $475.00 OBO, buyer pays shipping &amp; insurance.</p><p></p><p>Amplifier will be packaged like a pro, thoroughly wrapped, sealed, cushioned and double boxed.</p><p></p><p>Info/Specs:</p><p></p><p>The Mobile Professional Series provide their optimal power into low impedance loads such as 1 ohm bridged or .5 stereo.</p><p></p><p>The MPS series have much lower competition wattage ratings. They are often called "Cheater" amps because they allow competitors to compete in lower power brackets, when in reality they are using a lot more real world power.</p><p></p><p>Under-rated as the following:</p><p></p><p>Into 4 ohms @ 12.5/14.4 VDC 50/80 WRMS x 2</p><p></p><p>Into 2 ohms @ 14.4 VDC 125 WRMS x 2</p><p></p><p>Bridged into 2 ohm @ 14.4 VDC 510 WRMS x 1</p><p></p><p>Frequency Response +/-1dB from 20Hz to 20kHz</p><p></p><p>Signal to Noise Ratio &gt;100dB</p><p></p><p>Input Sensitivity 200 millivolts to 2 volts</p><p></p><p>Input Impedance &gt;30k ohms</p><p></p><p>Input Voltage Range 10.5 volts to 15.0 volts</p><p></p><p>Typical current draw at idle 3 amps</p><p></p><p>Minimum Impedance MPS series 1 ohm bridged/ .5 ohm stereo</p></blockquote><p></p>
[QUOTE="JayGold, post: 7004258, member: 583606"] So up for grabs is a very nice MPS-2500. Modified by Phoenix Gold to reflect the most current circuit board wiring as the TA (Team Amp) series. Cosmetics: 7.5/10.0 mainly rated due to the slight chipped coating on the end caps and cover which may be easily replaced if you can find them. The heat sink chassis is about a 9.0/10.0...still very glossy. Performance: Tested and operating fine, no signs of caps leaking but they will need to be replaced as a caution. Asking $475.00 OBO, buyer pays shipping & insurance. Amplifier will be packaged like a pro, thoroughly wrapped, sealed, cushioned and double boxed. Info/Specs: The Mobile Professional Series provide their optimal power into low impedance loads such as 1 ohm bridged or .5 stereo. The MPS series have much lower competition wattage ratings. They are often called "Cheater" amps because they allow competitors to compete in lower power brackets, when in reality they are using a lot more real world power. Under-rated as the following: Into 4 ohms @ 12.5/14.4 VDC 50/80 WRMS x 2 Into 2 ohms @ 14.4 VDC 125 WRMS x 2 Bridged into 2 ohm @ 14.4 VDC 510 WRMS x 1 Frequency Response +/-1dB from 20Hz to 20kHz Signal to Noise Ratio >100dB Input Sensitivity 200 millivolts to 2 volts Input Impedance >30k ohms Input Voltage Range 10.5 volts to 15.0 volts Typical current draw at idle 3 amps Minimum Impedance MPS series 1 ohm bridged/ .5 ohm stereo [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: Phoenix Gold MPS-2500
Top
Menu
Home
Refresh