Reply to thread

Message

<blockquote data-quote="bent70" data-source="post: 551438" data-attributes="member: 556898">The center console isn&#039;t going to be that bad.It&#039;ll 17&quot;x17&quot; in the back and quickly tapers down to 17&quot;w x 8.5&quot; tall. Depth will be 21&quot;, approximatly the depth of my seats. I&#039;ll bend the mdf to make the taper.(top sheet).It looks cool in my head and the template I made of the side profile.Currently, I have one set of extremis preordered. The only reason I was thinking of getting four would be to run each pair parallel to get a four ohm load for desent power out of an amp. I want to run bettween 150-250w to the components.I&#039;m not sure on the horn, since I really don&#039;t have any good spots to mount them. Plus, they will end up costing more than my budget will allow.So mounting the mids in the doors and tweets in the a-pillers or like sounds best.If I get some efficent tweets is there any reason why I can&#039;t run them off the deck through its eq. The deck is a pioneer p8600mp.thanks</blockquote>

[QUOTE="bent70, post: 551438, member: 556898"] The center console isn't going to be that bad. It'll 17"x17" in the back and quickly tapers down to 17"w x 8.5" tall. Depth will be 21", approximatly the depth of my seats. I'll bend the mdf to make the taper.(top sheet). It looks cool in my head and the template I made of the side profile. Currently, I have one set of extremis preordered. The only reason I was thinking of getting four would be to run each pair parallel to get a four ohm load for desent power out of an amp. I want to run bettween 150-250w to the components. I'm not sure on the horn, since I really don't have any good spots to mount them. Plus, they will end up costing more than my budget will allow. So mounting the mids in the doors and tweets in the a-pillers or like sounds best. If I get some efficent tweets is there any reason why I can't run them off the deck through its eq. The deck is a pioneer p8600mp. thanks [/QUOTE]

Verification