Reply to thread

Message

<blockquote data-quote="NewToTheGrounds" data-source="post: 3109253" data-attributes="member: 566589">im trying to tune my crossover frequency selection(FREQ) on my amp i have a ported box tuned to 32Hz i went through the gain settings for amps and a few others to look for a tut or help with setting freq my dial goes from 40 to 200, im not sure if i missed the tut on it any help would be great or if any one knows a page that can help me learn thanks. there was this but im not sure if its sumthing completely different or what i should be using .Setting the subsonic filter (if available):1) Determine the tuning frequency of your enclosure (if using a sealed enclosure, turn SSF off or to minimum frequency)2) Calculate the desired SSF frequency by using the formula: SSF = Tuning*3/43) If number is not whole, round to the nearest integer4) Write the SSF frequency down5) Calculate the desired SSF voltage by using the formula: SSF_Voltage = 0.707*Sub_Voltage6) Write the SSF voltage down7) Turn the SSF to the maximum frequency8) Set track to the SSF frequency and set to repeat track9) Set to volume written down in speaker setting stage10) Turn down the frequency on the SSF control until you reach the SSF Voltage from step 611) Turn the volume down to 0</blockquote>

[QUOTE="NewToTheGrounds, post: 3109253, member: 566589"] im trying to tune my crossover frequency selection(FREQ) on my amp i have a ported box tuned to 32Hz i went through the gain settings for amps and a few others to look for a tut or help with setting freq my dial goes from 40 to 200, im not sure if i missed the tut on it any help would be great or if any one knows a page that can help me learn thanks. there was this but im not sure if its sumthing completely different or what i should be using . Setting the subsonic filter (if available): 1) Determine the tuning frequency of your enclosure (if using a sealed enclosure, turn SSF off or to minimum frequency) 2) Calculate the desired SSF frequency by using the formula: SSF = Tuning*3/4 3) If number is not whole, round to the nearest integer 4) Write the SSF frequency down 5) Calculate the desired SSF voltage by using the formula: SSF_Voltage = 0.707*Sub_Voltage 6) Write the SSF voltage down 7) Turn the SSF to the maximum frequency 8) Set track to the SSF frequency and set to repeat track 9) Set to volume written down in speaker setting stage 10) Turn down the frequency on the SSF control until you reach the SSF Voltage from step 6 11) Turn the volume down to 0 [/QUOTE]

Verification