Reply to thread

Message: <blockquote data-quote="dkguitarist" data-source="post: 1703776" data-attributes="member: 557124">x2. take the paint gun apart and set it in a bucket of thinner for like 15 mins then pull parts out, wipe down, and reassemble. make sure all connections are good as well.also pressure in teh booth should keep all the particles in the air from flying around and pull them down thru the vents.check the pressure of the booth.and always wetsand between each layer of basecoat and before clearing. use tach cloth and grease/wax remover to clean the surface.(learned all this in my auto repair class 3-4 years ago).</blockquote>

Top