Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
First time LOC user and looking for suggestions on tapping into the factory wires!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="fatboytyler" data-source="post: 8639876" data-attributes="member: 658624"><p>Well without 0 tweaking my door speakers were up and running and sounding quite well after I banged my head against the wall because of Toyota's genius electrical engineers, but then I decided to yank a wire out in my door somewhere disconnecting my driver door speakers when I rolled down my window...</p><p></p><p>Its so ******* weird. Toyota has the tweeters in the dash (which had twice the magnet as the factory 6x9s...) with a completely separate cable run to them. So I hooked into both of them at the speaker, after all of Toyota's adapters expecting them to have been filtered out, then just combining them at the LC7i... Well no, it seems Toyota sends full range signals to both... Then the LC7i's signal sense turn on will only turn on with the mid's wire and not the one tapped at the tweeter, YET the tweeter one is still sending signal that is playable through a speaker...</p></blockquote><p></p>
[QUOTE="fatboytyler, post: 8639876, member: 658624"] Well without 0 tweaking my door speakers were up and running and sounding quite well after I banged my head against the wall because of Toyota's genius electrical engineers, but then I decided to yank a wire out in my door somewhere disconnecting my driver door speakers when I rolled down my window... Its so ******* weird. Toyota has the tweeters in the dash (which had twice the magnet as the factory 6x9s...) with a completely separate cable run to them. So I hooked into both of them at the speaker, after all of Toyota's adapters expecting them to have been filtered out, then just combining them at the LC7i... Well no, it seems Toyota sends full range signals to both... Then the LC7i's signal sense turn on will only turn on with the mid's wire and not the one tapped at the tweeter, YET the tweeter one is still sending signal that is playable through a speaker... [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
First time LOC user and looking for suggestions on tapping into the factory wires!
Top
Menu
Home
Refresh