Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
First post- opinions on my potential setup. SQ, Processors, components, Jeep.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Tenacious" data-source="post: 8021512" data-attributes="member: 642017"><p>1. I'd go for the components. You don't really need a 3 way speaker if you have a sub.</p><p></p><p>2. I'd disconnect the dash speakers and mount the component's tweeters where the stock tweeters are. Later on you could look into replacing the dash speakers if you wanted to, but it's probably not neccessary</p><p></p><p>3. Wire like you normally would? Just set your amps gain to give the proper amount of power</p><p></p><p>4. You probably won't need a signal processor. Install everything else first and see if you like how it sounds.</p><p></p><p>5. Sealed would be fine, ported would be louder. A good ported box doesn't sacrifice SQ, however you will lose some of your 60-80Hz output being tuned at 33-35 Hz (which is a good tuning for your music taste)</p><p></p><p>Other comments:</p><p></p><p>I'd set the LPF on the sub amp to about 80Hz and the HPF on the mids/highs amp to the same.</p></blockquote><p></p>
[QUOTE="Tenacious, post: 8021512, member: 642017"] 1. I'd go for the components. You don't really need a 3 way speaker if you have a sub. 2. I'd disconnect the dash speakers and mount the component's tweeters where the stock tweeters are. Later on you could look into replacing the dash speakers if you wanted to, but it's probably not neccessary 3. Wire like you normally would? Just set your amps gain to give the proper amount of power 4. You probably won't need a signal processor. Install everything else first and see if you like how it sounds. 5. Sealed would be fine, ported would be louder. A good ported box doesn't sacrifice SQ, however you will lose some of your 60-80Hz output being tuned at 33-35 Hz (which is a good tuning for your music taste) Other comments: I'd set the LPF on the sub amp to about 80Hz and the HPF on the mids/highs amp to the same. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
First post- opinions on my potential setup. SQ, Processors, components, Jeep.
Top
Menu
Home
Refresh