Reply to thread

Message: <blockquote data-quote="geowick07" data-source="post: 2594083" data-attributes="member: 568423">As you can see from above, you have a couple options.1. Just drill holes where you want the wire to be, and run them through. Just be sure to seal them up afterward.2. Terminal cups are better-looking, and need to be sealed after installation.3. Binding posts - These are what I used. You just drill a 1/4" hole, fill it with silicone, tap them in place, and tighten them up. On most, you have the choice of using bare wire, banana plugs, or spade connectors. Have a look on this site. A lot of good accessories on here for a decent price! <a href="http://www.partsexpress.com/" target="_blank">PartsExpress.com</a></blockquote>

Top