Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
finding freq points on active crossover?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="audioholic" data-source="post: 7496245" data-attributes="member: 549629"><p>The reason the xover point jumps so drastically is because of the components used. Put simply, the frequency point does not scale linear with the turning of the knob.</p><p></p><p>I suspect manufacturers dont bother putting more marks on the knob positions because they realize the unit isn't accurate enough to guarantee the indicated point would correspond with that frequency.</p><p></p><p>Both of the above mentioned problems only really apply to analog pieces. Digital is where the industry is heading, so I doubt we'll see much/any development in analog units in regards to issues like this.</p><p></p><p>You can verify crossover settings either by using an rta and a sine sweep, or test tones and a db meter (or your ear).</p></blockquote><p></p>
[QUOTE="audioholic, post: 7496245, member: 549629"] The reason the xover point jumps so drastically is because of the components used. Put simply, the frequency point does not scale linear with the turning of the knob. I suspect manufacturers dont bother putting more marks on the knob positions because they realize the unit isn't accurate enough to guarantee the indicated point would correspond with that frequency. Both of the above mentioned problems only really apply to analog pieces. Digital is where the industry is heading, so I doubt we'll see much/any development in analog units in regards to issues like this. You can verify crossover settings either by using an rta and a sine sweep, or test tones and a db meter (or your ear). [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
finding freq points on active crossover?
Top
Menu
What's new
Forum list
