Reply to thread

Message

<blockquote data-quote="peejglass" data-source="post: 8572026" data-attributes="member: 673097">Hey all I have been lurking for a long time and just now decided to register and start posting. I have a decent bit of knowledge on car audio at this point and am currently planning out my mids and highs setup (likely PRV 8s and supertweets) because my sub was drowning out most of the actual music if I played full tilt...that being said my sub (HDC315) just started getting some coil rub so it&#039;s as good a time as any to recone and drop down to 0.5 ohm. Eventually I am planning to wall off my little ford focus with two of these babies so I&#039;ll end up back at 1 ohm when I get a more powerful amp.Well not really much else to say just wanted to make some sort of introduction post! Thanks everyone for all the info I&#039;ve read on these forums without being a member //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifOh and PS the validation question still thinks that Obama is our president so some admin may want to change that lol!</blockquote>

[QUOTE="peejglass, post: 8572026, member: 673097"] Hey all I have been lurking for a long time and just now decided to register and start posting. I have a decent bit of knowledge on car audio at this point and am currently planning out my mids and highs setup (likely PRV 8s and supertweets) because my sub was drowning out most of the actual music if I played full tilt...that being said my sub (HDC315) just started getting some coil rub so it's as good a time as any to recone and drop down to 0.5 ohm. Eventually I am planning to wall off my little ford focus with two of these babies so I'll end up back at 1 ohm when I get a more powerful amp. Well not really much else to say just wanted to make some sort of introduction post! Thanks everyone for all the info I've read on these forums without being a member [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] Oh and PS the validation question still thinks that Obama is our president so some admin may want to change that lol! [/QUOTE]

Verification