Reply to thread

Message

<blockquote data-quote="Rashaddd" data-source="post: 5045820" data-attributes="member: 592162">Um...are you lost lol?I&#039;m working with it right now, port length, unsure. If WinISD shows a port velocity of .05 that means I should be fine port noise-wise, even without the flares right? Its going to be difficult to fit the bottom flares in, so I&#039;m thinking I&#039;ll just leave em off, how will having only one side (the outer side coming out the rear deck) flared compare to having both sides of the ports flared?Oh and, I mentioned earlier, but no the ports wont just be sticking out like that, there&#039;s my rear deck inbetween, and then I&#039;ll build a rear deck covering with mounting rings where the ports will be, and eventually redo that and make my whole rear deck covering fiberglassed and paint it nice and shiny. Half the motivation for this install is how fvcking nice and clean its going to look (I hope) especially with the seats up.</blockquote>

[QUOTE="Rashaddd, post: 5045820, member: 592162"] Um...are you lost lol? I'm working with it right now, port length, unsure. If WinISD shows a port velocity of .05 that means I should be fine port noise-wise, even without the flares right? Its going to be difficult to fit the bottom flares in, so I'm thinking I'll just leave em off, how will having only one side (the outer side coming out the rear deck) flared compare to having both sides of the ports flared? Oh and, I mentioned earlier, but no the ports wont just be sticking out like that, there's my rear deck inbetween, and then I'll build a rear deck covering with mounting rings where the ports will be, and eventually redo that and make my whole rear deck covering fiberglassed and paint it nice and shiny. Half the motivation for this install is how fvcking nice and clean its going to look (I hope) especially with the seats up. [/QUOTE]

Verification