Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Factory Bose System is 300 Watts, does this limit me going larger with Sub and Amp?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Tim Ivory" data-source="post: 8659502" data-attributes="member: 675832"><p>I'm shooting for 60/40, max 75/25, subs on top on both ratios, so a range 450-900 RMS output, while keeping the factory.</p><p></p><p>I have my mind set on 2 12 inch subs. Does this mean I need to go DVC here, thus also allowing either 450 or 900 watt output depending non serial or parallel. This way, if 900 is too much, I have plan b, which his wire them in serial to double the impedance (half the watts). DVC means I loose efficiency, especially in a sealed sub box, since the OHMS will likely be either 2 or 4 in this case, while I was hoping for a simpler mono channel system that is efficient at 1 ohm. Is 1 ohm possible for a 2 sub system?</p></blockquote><p></p>
[QUOTE="Tim Ivory, post: 8659502, member: 675832"] I'm shooting for 60/40, max 75/25, subs on top on both ratios, so a range 450-900 RMS output, while keeping the factory. I have my mind set on 2 12 inch subs. Does this mean I need to go DVC here, thus also allowing either 450 or 900 watt output depending non serial or parallel. This way, if 900 is too much, I have plan b, which his wire them in serial to double the impedance (half the watts). DVC means I loose efficiency, especially in a sealed sub box, since the OHMS will likely be either 2 or 4 in this case, while I was hoping for a simpler mono channel system that is efficient at 1 ohm. Is 1 ohm possible for a 2 sub system? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Factory Bose System is 300 Watts, does this limit me going larger with Sub and Amp?
Top
Menu
Home
Refresh