Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Classifieds
f/s xtant 3300x
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="limitkid7" data-source="post: 824187" data-attributes="member: 545328"><p>Frequency Response 5 Hz to 50 kHz +/– 1 dB</p><p></p><p>Number of Channels 3</p><p></p><p>Watts per Channel @ 4Ω 2 x 60 + 1 x 180</p><p></p><p>Watts per Channel @ 2Ω 2 x 120 + 1 x 360</p><p></p><p>Bridged Mono @ 4Ω (Stereo Channels) 1 x 240</p><p></p><p>Recommended Load (stereo channels) &gt;2Ω Stereo / &gt;4Ω Bridged</p><p></p><p>Recommended Load (Mono channel) &gt;2Ω</p><p></p><p>Distortion (THD)</p><p></p><p>Measured: 20 Hz to 20 kHz at rated power, all channels driven 4Ω</p><p></p><p>Signal to Noise Ratio &gt; 100 dB</p><p></p><p>Measured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity</p><p></p><p>Damping Factor &gt; 200 @ 100 Hz with 4Ω load</p><p></p><p>Input Sensitivity 100 mV to 8.5 V RMS Unbalanced Source</p><p></p><p>100 mV to 17 V RMS Balanced Source</p><p></p><p>Input to Line Output Gain 0 dB +/– 20 dB, Selectable in 10 dB steps</p><p></p><p>On-Board Crossover 12 dB per Octave “Butterworth”</p><p></p><p>Module Port(s) 2 – Accessory and 2 – Balanced Line</p><p></p><p>Power Supply Fully Regulated, PWM</p><p></p><p>Operational Voltage 11 to 15 Volts</p><p></p><p><a href="http://www.xtant.com/html/techSupport/pdfs/3300xMan.pdf" target="_blank">http://www.xtant.com/html/techSupport/pdfs/3300xMan.pdf</a></p></blockquote><p></p>
[QUOTE="limitkid7, post: 824187, member: 545328"] Frequency Response 5 Hz to 50 kHz +/– 1 dB Number of Channels 3 Watts per Channel @ 4Ω 2 x 60 + 1 x 180 Watts per Channel @ 2Ω 2 x 120 + 1 x 360 Bridged Mono @ 4Ω (Stereo Channels) 1 x 240 Recommended Load (stereo channels) >2Ω Stereo / >4Ω Bridged Recommended Load (Mono channel) >2Ω Distortion (THD) Measured: 20 Hz to 20 kHz at rated power, all channels driven 4Ω Signal to Noise Ratio > 100 dB Measured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity Damping Factor > 200 @ 100 Hz with 4Ω load Input Sensitivity 100 mV to 8.5 V RMS Unbalanced Source 100 mV to 17 V RMS Balanced Source Input to Line Output Gain 0 dB +/– 20 dB, Selectable in 10 dB steps On-Board Crossover 12 dB per Octave “Butterworth” Module Port(s) 2 – Accessory and 2 – Balanced Line Power Supply Fully Regulated, PWM Operational Voltage 11 to 15 Volts [URL="http://www.xtant.com/html/techSupport/pdfs/3300xMan.pdf"]http://www.xtant.com/html/techSupport/pdfs/3300xMan.pdf[/URL] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Classifieds
f/s xtant 3300x
Top
Menu
What's new
Forum list
