Reply to thread

Message

<blockquote data-quote="los33" data-source="post: 8564058" data-attributes="member: 660834">So again your basically throwing numbers from your guesses?Carbide, tooling for Mills are not free. A new program or modified program is needed for new cnc adaptation cuts.JUST for a top plate the process is-Roughing-Cutting/shaping (which takes 30mins to an hour)-Fine tooling which requires depending by design drilling, then 8 round, 10 round or GB threading-Skimming to smooth surface-More drilling for poll/coilNot to mention having to re-indicating when swapping from machines.Grinding/smoothing corners/edges, threads.Then Q/A for proper specs as even the slightest mistake will throw off specs.IF it passes then it is ready to move on.You really do not know the process and even a large build house will not waste 1k on that much work.Sent from my Z970 using Tapatalk</blockquote>

[QUOTE="los33, post: 8564058, member: 660834"] So again your basically throwing numbers from your guesses? Carbide, tooling for Mills are not free. A new program or modified program is needed for new cnc adaptation cuts. JUST for a top plate the process is -Roughing -Cutting/shaping (which takes 30mins to an hour) -Fine tooling which requires depending by design drilling, then 8 round, 10 round or GB threading -Skimming to smooth surface -More drilling for poll/coil Not to mention having to re-indicating when swapping from machines. Grinding/smoothing corners/edges, threads. Then Q/A for proper specs as even the slightest mistake will throw off specs. IF it passes then it is ready to move on. You really do not know the process and even a large build house will not waste 1k on that much work. Sent from my Z970 using Tapatalk [/QUOTE]

Verification