Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Dupuius - please read.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="baja_stx" data-source="post: 422277" data-attributes="member: 554157"><p>Nice install... very clean and professional looking. Good job on the box too. I have a couple questions for you.</p><p></p><p>1) In your opion. Do you think the two RE8's are a better choice than the RF10 HX2? Did you use the 8's because you already had them or did you prefer two 8's over one 10?</p><p></p><p>2) How do you like the Infinity's? I haven't decided on what door speakers to use yet.</p><p></p><p>3) For your 4 channel amp. I see you used RCA's. Do you have an aftermarket HU or did you use a speaker to RCA converter? If you still have the stock radio why didn't you use the high/speaker inputs on the amp?</p><p></p><p>4) For your 2 channel amp. Did/do you have the Ford Audiophile system? If so, did you use any of the factory wiring that was running to the factory sub amp?</p><p></p><p>5) I was planning on running/extending the factory speaker wires from the HU to the speaker/high inputs on my 4 CH amp and then run new speaker wire to each of the 4 door speakers. I then plan on hooking up my mono amp to the 4 CH amp's pre-outs. Does this sound ok? Any recommendations?</p><p></p><p>6) Is your passenger seat power? My passenger seat is power and it doesn't look like I have as much room as you do. I made an aluminum rack to stack both my amps where the spare tire jack was. I used the two jack bolts and the right front seat bolt to secure the rack. I left 1" between the amps and have two 80mm computer fans blowing across them. Yes I have the amps already... they've been sitting next to my desk screaming to get hooked up, but I can't decide what to do about the sub box.</p><p></p><p>Sorry for all the questions. You're system is the first I've seen in a 04 F150 and it's very similar to what I want.</p><p></p><p>Again... Very clean job on your system.</p></blockquote><p></p>
[QUOTE="baja_stx, post: 422277, member: 554157"] Nice install... very clean and professional looking. Good job on the box too. I have a couple questions for you. 1) In your opion. Do you think the two RE8's are a better choice than the RF10 HX2? Did you use the 8's because you already had them or did you prefer two 8's over one 10? 2) How do you like the Infinity's? I haven't decided on what door speakers to use yet. 3) For your 4 channel amp. I see you used RCA's. Do you have an aftermarket HU or did you use a speaker to RCA converter? If you still have the stock radio why didn't you use the high/speaker inputs on the amp? 4) For your 2 channel amp. Did/do you have the Ford Audiophile system? If so, did you use any of the factory wiring that was running to the factory sub amp? 5) I was planning on running/extending the factory speaker wires from the HU to the speaker/high inputs on my 4 CH amp and then run new speaker wire to each of the 4 door speakers. I then plan on hooking up my mono amp to the 4 CH amp's pre-outs. Does this sound ok? Any recommendations? 6) Is your passenger seat power? My passenger seat is power and it doesn't look like I have as much room as you do. I made an aluminum rack to stack both my amps where the spare tire jack was. I used the two jack bolts and the right front seat bolt to secure the rack. I left 1" between the amps and have two 80mm computer fans blowing across them. Yes I have the amps already... they've been sitting next to my desk screaming to get hooked up, but I can't decide what to do about the sub box. Sorry for all the questions. You're system is the first I've seen in a 04 F150 and it's very similar to what I want. Again... Very clean job on your system. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Dupuius - please read.
Top
Menu
What's new
Forum list