Reply to thread

Message: <blockquote data-quote="kizzo" data-source="post: 2569839" data-attributes="member: 568176">When i was installing my Profile CA600 to run my Cadence cwm6 components i left the amp on and running while i was messing around trying to configure the speaker wire setup.  After i did this i think i either blew the xover on the amp or the xover on the components set itself.Im pretty sure its the crossovers because certain lows will now work and some highs wont.  Sound get through and sounds clean, but a lot of the music is either totally left out or just drowned out.How can i check which is blown?</blockquote>

Top