Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
DIY Component Drivers.. What's out there that's respected
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Babs" data-source="post: 3204179" data-attributes="member: 567066"><p>After way too much reading over at diyma, and at zaphaudio.com 6.5 driver review.. I'll probably end up going Seas all around with some RNX's of some kind and Neo tweets of either alum or textile dome. Or go nextel cone Excel's.</p><p></p><p>On a budget, the CD18RE-MDS that's on special is getting good reviews, and the new ER18RNX is looking pretty nice.</p><p></p><p>I get the impression with say $120 in the mids and $60ish or so in the tweets, that's a lot of 2-way for around $200 compared to what you can buy in a car-audio marketed setup.. Those guys are comparing their diy setups to some rather high-end comps like dynaudio, focal, etc in some of their comparison reviews.. I'm not surprised.. Good passive x-overs aren't exactly cheap, nor is the "car-audio" specific markup.</p></blockquote><p></p>
[QUOTE="Babs, post: 3204179, member: 567066"] After way too much reading over at diyma, and at zaphaudio.com 6.5 driver review.. I'll probably end up going Seas all around with some RNX's of some kind and Neo tweets of either alum or textile dome. Or go nextel cone Excel's. On a budget, the CD18RE-MDS that's on special is getting good reviews, and the new ER18RNX is looking pretty nice. I get the impression with say $120 in the mids and $60ish or so in the tweets, that's a lot of 2-way for around $200 compared to what you can buy in a car-audio marketed setup.. Those guys are comparing their diy setups to some rather high-end comps like dynaudio, focal, etc in some of their comparison reviews.. I'm not surprised.. Good passive x-overs aren't exactly cheap, nor is the "car-audio" specific markup. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
DIY Component Drivers.. What's out there that's respected
Top
Menu
What's new
Forum list
