Reply to thread

Message

<blockquote data-quote="req" data-source="post: 647915" data-attributes="member: 555713">i know they are 4 ohm stable when bridged.im going to be bridging 1&amp;amp;2 @ 8ohms for horn1, and 3&amp;amp;4 @8ohms for horn2 - squeak told me id be like 37 watts and some change. and audiolife told me 35watts would make my ears bleed. so ill be turning the gain on them channels down //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifthen ill be running each koda off channels 5(koda1) and 6 (koda2) because the sub channel is on its own powersupply.im not sure if you can bridge 5&amp;amp;6@2 though.. lemme check. i got the PDF right here...[insert jeproady music]it says that;1&amp;amp;2 \\ 3&amp;amp;4 bridged @4 will give ya 150w x25&amp;amp;6 bridged @4 will give ya 250w x1it says you can run 5 and 6 SEPERATLY @2ohms, but it does not say weather you can or cant bridge 5&amp;amp;6@2. i would say no, most PPI\DEI\ADS stuff was not able to be bridged less than 4ohms. id keep it bridged at 4 if i were you&nbsp; //content.invisioncic.com/y282845/emoticons/banghead.gif.8606515f668c74f6de0281deb475b6fd.gif</blockquote>

[QUOTE="req, post: 647915, member: 555713"] i know they are 4 ohm stable when bridged. im going to be bridging 1&2 @ 8ohms for horn1, and 3&4 @8ohms for horn2 - squeak told me id be like 37 watts and some change. and audiolife told me 35watts would make my ears bleed. so ill be turning the gain on them channels down [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] then ill be running each koda off channels 5(koda1) and 6 (koda2) because the sub channel is on its own powersupply. im not sure if you can bridge 5&6@2 though.. lemme check. i got the PDF right here... [insert jeproady music] it says that; 1&2 \\ 3&4 bridged @4 will give ya 150w x2 5&6 bridged @4 will give ya 250w x1 it says you can run 5 and 6 SEPERATLY @2ohms, but it does not say weather you can or cant bridge 5&6@2. i would say no, most PPI\DEI\ADS stuff was not able to be bridged less than 4ohms. id keep it bridged at 4 if i were you [IMG]//content.invisioncic.com/y282845/emoticons/banghead.gif.8606515f668c74f6de0281deb475b6fd.gif[/IMG] [/QUOTE]

Verification