Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
difference from a sub clipping and bottoming
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mass Car Audio" data-source="post: 6013554" data-attributes="member: 604291"><p>A clipped signal is nothing like putting dc current to your subs. Clipping is a form of waveform distortion that occurs when an amplifier is overdriven, which happens through attempts to increase the voltage or current beyond its maximum power capability. Driving an amplifier into clipping causes it to put out power in excess of its published ratings, which are customarily done with a "clean" sine wave signal just at the onset of clipping. Also when an amplifier is pushed to create a signal with more power than its power supply can produce, it will amplify the signal only up to its maximum capacity, at which point the signal will be amplified no further. As the signal simply "cuts" or "clips" at the maximum capacity of the amplifier, the signal is said to be "clipping". The extra signal which is beyond the capability of the amplifier is simply cut off, resulting in a sine wave becoming a distorted square wave type waveform.</p></blockquote><p></p>
[QUOTE="Mass Car Audio, post: 6013554, member: 604291"] A clipped signal is nothing like putting dc current to your subs. Clipping is a form of waveform distortion that occurs when an amplifier is overdriven, which happens through attempts to increase the voltage or current beyond its maximum power capability. Driving an amplifier into clipping causes it to put out power in excess of its published ratings, which are customarily done with a "clean" sine wave signal just at the onset of clipping. Also when an amplifier is pushed to create a signal with more power than its power supply can produce, it will amplify the signal only up to its maximum capacity, at which point the signal will be amplified no further. As the signal simply "cuts" or "clips" at the maximum capacity of the amplifier, the signal is said to be "clipping". The extra signal which is beyond the capability of the amplifier is simply cut off, resulting in a sine wave becoming a distorted square wave type waveform. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
difference from a sub clipping and bottoming
Top
Menu
What's new
Forum list