Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Diamond D3 10 box design help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="YukonXL04" data-source="post: 8661578" data-attributes="member: 672770"><p>Hey guys, looking for some help on designing a box for this diamond D3 10 I have laying around. It will be used in my garage with a 200w sub plate amp I have. Both are laying around and would like to put them to use. </p><p></p><p>Efficiency is going to be key here. Looking for a bandwidth of roughly 28-55 hz or so. Was thinking maybe 4th or 6th order. Maybe even a 1/4 wave T Line. Need some good output vs a standard 1.0 ported box it's in now. Tuned to 35hz currently. It plays well, I just have a large pro audio 2way cabinets its gotta hang with. Really only at low to mid volume. No way will it hang when cranked up though. Max dimensions are roughly 18wx26h x 24d smaller in all directions would be preferred though. TS specs attatched.</p><p></p><p>[ATTACH]2297[/ATTACH]</p></blockquote><p></p>
[QUOTE="YukonXL04, post: 8661578, member: 672770"] Hey guys, looking for some help on designing a box for this diamond D3 10 I have laying around. It will be used in my garage with a 200w sub plate amp I have. Both are laying around and would like to put them to use. Efficiency is going to be key here. Looking for a bandwidth of roughly 28-55 hz or so. Was thinking maybe 4th or 6th order. Maybe even a 1/4 wave T Line. Need some good output vs a standard 1.0 ported box it's in now. Tuned to 35hz currently. It plays well, I just have a large pro audio 2way cabinets its gotta hang with. Really only at low to mid volume. No way will it hang when cranked up though. Max dimensions are roughly 18wx26h x 24d smaller in all directions would be preferred though. TS specs attatched. [ATTACH]2297._xfImport[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Diamond D3 10 box design help
Top
Menu
Home
Refresh