Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Designing and Building a simple HP crossover
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="thch" data-source="post: 1701764" data-attributes="member: 562032"><p>you might concider using a lower slope. typically you need large components for low frequency and low impedances.</p><p></p><p>if L-R is "linkwitz riley", and your talking about 2nd order, then there is probably no point. The LR crossover was designed to be phase coherent and sum acoustically flat when used with both high and lowpass filters. just using a highpass means you end up with a butterworth filter (at a different frequency). this is probably fine.</p><p></p><p>you may want an iron core inductor for that large of a value. the capacitor is realistic, but large.</p></blockquote><p></p>
[QUOTE="thch, post: 1701764, member: 562032"] you might concider using a lower slope. typically you need large components for low frequency and low impedances. if L-R is "linkwitz riley", and your talking about 2nd order, then there is probably no point. The LR crossover was designed to be phase coherent and sum acoustically flat when used with both high and lowpass filters. just using a highpass means you end up with a butterworth filter (at a different frequency). this is probably fine. you may want an iron core inductor for that large of a value. the capacitor is realistic, but large. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Designing and Building a simple HP crossover
Top
Menu
Home
Refresh