Reply to thread

Message

<blockquote data-quote="geolemon" data-source="post: 737721" data-attributes="member: 547749">I wrote my own software... but it&#039;s only good for rectangular enclosures.Logic built in, though, to calculate what panels I need based on the dimensions I input (two of the three), material thickness, various internal displacements, and of course the airspace I&#039;m shooting for... and then calculates how to best lay those panels out on a sheet of MDF (I specify the dimensions of the sheet - handy for making use of scraps!) so they&#039;ll best fit, and then it plots it all out and gives me a printout.Downside:It&#039;s only good for rectangular enclosures.I suppose I could expand it... but then I&#039;d have to have it calculate which cuts had to be cut with the blade set at what angle, and all that... sounds like a lot of work. //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif</blockquote>

[QUOTE="geolemon, post: 737721, member: 547749"] I wrote my own software... but it's only good for rectangular enclosures. Logic built in, though, to calculate what panels I need based on the dimensions I input (two of the three), material thickness, various internal displacements, and of course the airspace I'm shooting for... and then calculates how to best lay those panels out on a sheet of MDF (I specify the dimensions of the sheet - handy for making use of scraps!) so they'll best fit, and then it plots it all out and gives me a printout. Downside: It's only good for rectangular enclosures. I suppose I could expand it... but then I'd have to have it calculate which cuts had to be cut with the blade set at what angle, and all that... sounds like a lot of work. [IMG]//content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif[/IMG] [/QUOTE]

Verification