Reply to thread

Message

<blockquote data-quote="hempy" data-source="post: 3937153" data-attributes="member: 571956">It&#039;ll probably be sometime Friday or this weekend.&nbsp; I just haven&#039;t had the time between work and school to get enough listening/testing time in as I would like.&nbsp; I also need to set the gain correctly on both amps.&nbsp; I basically just set them low and put everything in.&nbsp; Once I&#039;ve played with it for a bit I&#039;ll sit down and set everything.I was a little surprised at the coil impedance.. They&#039;re listed at 1.8, while they read 3.6-4.0 each.&nbsp; I know impedance rise will change the load, but this was fresh out of the box, and I&#039;ve had other woofers read much closer to publish specifications.Just got it today.&nbsp; I&#039;m actually looking to cover up the fans.&nbsp; Since apparently case fans don&#039;t reverse with reversed voltage, I had to switch one of the sets around, ruining my nice symmetry.&nbsp; So im going to cut some square rings to fit the holes and stretch the cloth over them.&nbsp;&nbsp; Hopefully it&#039;ll allow enough airflow.&nbsp; If not, I can always up the voltage.&nbsp; I think I have them at 6 right now.</blockquote>

[QUOTE="hempy, post: 3937153, member: 571956"] It'll probably be sometime Friday or this weekend. I just haven't had the time between work and school to get enough listening/testing time in as I would like. I also need to set the gain correctly on both amps. I basically just set them low and put everything in. Once I've played with it for a bit I'll sit down and set everything. I was a little surprised at the coil impedance.. They're listed at 1.8, while they read 3.6-4.0 each. I know impedance rise will change the load, but this was fresh out of the box, and I've had other woofers read much closer to publish specifications. Just got it today. I'm actually looking to cover up the fans. Since apparently case fans don't reverse with reversed voltage, I had to switch one of the sets around, ruining my nice symmetry. So im going to cut some square rings to fit the holes and stretch the cloth over them. Hopefully it'll allow enough airflow. If not, I can always up the voltage. I think I have them at 6 right now. [/QUOTE]

Verification