Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Crunch Ground Pounder2000.1 Power Light on but no power to subs & "V" Light.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Team Maxxsonics" data-source="post: 7052533" data-attributes="member: 564651"><p>It could be as simple as the remote circuit not providing enough voltage or possibly being current limited under load.</p><p></p><p>Try the following and if this does not work, call tech support at 877-629-9227 for a complete run through.</p><p></p><p>This is assuming you have a proper power and ground source.</p><p></p><p>1. Disconnect the remote wire from the amp (very important).</p><p></p><p>2. Place a jumper wire from the remote terminal on the amp to the + battery input terminal on the amp.</p><p></p><p>3. If the "V" illuminates, turn on the head unit and if the amp now works (the sub is playing), the problem is that the remote wire from the head unit is not supplying enough voltage to turn the amp on completely. This would be a bad connection or possibly a bad head unit.</p><p></p><p>4. If the "V" does not illuminate, call the tech support number above for further assistance.</p><p></p><p>Hope this helps.</p></blockquote><p></p>
[QUOTE="Team Maxxsonics, post: 7052533, member: 564651"] It could be as simple as the remote circuit not providing enough voltage or possibly being current limited under load. Try the following and if this does not work, call tech support at 877-629-9227 for a complete run through. This is assuming you have a proper power and ground source. 1. Disconnect the remote wire from the amp (very important). 2. Place a jumper wire from the remote terminal on the amp to the + battery input terminal on the amp. 3. If the "V" illuminates, turn on the head unit and if the amp now works (the sub is playing), the problem is that the remote wire from the head unit is not supplying enough voltage to turn the amp on completely. This would be a bad connection or possibly a bad head unit. 4. If the "V" does not illuminate, call the tech support number above for further assistance. Hope this helps. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Crunch Ground Pounder2000.1 Power Light on but no power to subs & "V" Light.
Top
Menu
Home
Refresh