Reply to thread

Message

<blockquote data-quote="beaver6713" data-source="post: 8706617" data-attributes="member: 679863">Hello,I am new to the site, hope I can get some help as I have put a fair amount of money into my build, now need to tune it. I have the Kenwood DNX892 HU, Focal 6.5 inch fx series components front and rear doors, (2) 10&quot; Image Dynamic subs in a ported box, JL Auido RD400/4 for the mids and tweeters, Rockford Fosgate Prime R2/1200/1 for the subs, subs are wired at 1 ohm.With my HU set at flat I used the SMD DD-1 to set both amp gains. HU clips at 30 so I run it max 28.My question is how and what to set the crossovers at?The focals FS is 70. The following settings are in the HU itself, I have the amp crossovers bypassed as I have heard that you do not want to use both at the same time.I currently have the HP set at 120HZ with a slope of 12db and the LP set at 100HZ with a slope of 12db.Are these settings close to what they should be?Thanks</blockquote>

[QUOTE="beaver6713, post: 8706617, member: 679863"] Hello,I am new to the site, hope I can get some help as I have put a fair amount of money into my build, now need to tune it. I have the Kenwood DNX892 HU, Focal 6.5 inch fx series components front and rear doors, (2) 10" Image Dynamic subs in a ported box, JL Auido RD400/4 for the mids and tweeters, Rockford Fosgate Prime R2/1200/1 for the subs, subs are wired at 1 ohm. With my HU set at flat I used the SMD DD-1 to set both amp gains. HU clips at 30 so I run it max 28. My question is how and what to set the crossovers at? The focals FS is 70. The following settings are in the HU itself, I have the amp crossovers bypassed as I have heard that you do not want to use both at the same time. I currently have the HP set at 120HZ with a slope of 12db and the LP set at 100HZ with a slope of 12db. Are these settings close to what they should be? Thanks [/QUOTE]

Verification