Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Crossover Settings for a 12inch sub
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="sLyx620" data-source="post: 4448878" data-attributes="member: 569444"><p>I am currently running a 12in. Memphis M1 in a 1cu ft sealed box being pushed by a kicker zx400.1 (true output 490 watts rms). It is firing towards the rear of the car. I have already set the gains using the tutorial (all crossovers off, 60hz -3db test tone . . .) The deck is an older premier deh p770mp.</p><p></p><p>When the LPF was set to 80hz on the head unit, the sub seems to run out of steam and just does not want to play loud or low. A single 10inch infinity ref powered by 300 watts was playing louder/lower and hit harder then my memphis. However, after tuning the cross over to approximately 60hz on the kicker amp, the sub plays lower and louder.</p><p></p><p>Could there be a problem with my sub/sub box design?</p><p></p><p>Also what is the typical crossover setting for a 12inch subwoofer?</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="sLyx620, post: 4448878, member: 569444"] I am currently running a 12in. Memphis M1 in a 1cu ft sealed box being pushed by a kicker zx400.1 (true output 490 watts rms). It is firing towards the rear of the car. I have already set the gains using the tutorial (all crossovers off, 60hz -3db test tone . . .) The deck is an older premier deh p770mp. When the LPF was set to 80hz on the head unit, the sub seems to run out of steam and just does not want to play loud or low. A single 10inch infinity ref powered by 300 watts was playing louder/lower and hit harder then my memphis. However, after tuning the cross over to approximately 60hz on the kicker amp, the sub plays lower and louder. Could there be a problem with my sub/sub box design? Also what is the typical crossover setting for a 12inch subwoofer? Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Crossover Settings for a 12inch sub
Top
Menu
What's new
Forum list
