Reply to thread

Message: <blockquote data-quote="reneeb7363" data-source="post: 2294493" data-attributes="member: 569914"><p>solder is pretty basic, wether you are soldering copper plumbing, lg awg wire...whatever... it MUST be clean and have a good mechanical connection. Solder follows heat so once you have accomplished the first two steps it is just a matter of heating the material, you are applyiing the solder to, up enough that when you apply said lead/tin compound it is "pulled into the material and creates a good "ELECTRICAL" connection. For larger ga. stuff and copper pipe you MUST use some kind of flux to ensure adhesion. (and cleanliness)</p></blockquote><p></p>

Top