Reply to thread

Message: <blockquote data-quote="Pioneer~Saturn" data-source="post: 5556117" data-attributes="member: 569334">For the crimping I would put the wire in the ring terminal and before you crimp it down...put some small pieces of solder in the ring terminal with the strands so that they dont fall out....then crimp it with a vise, putting a small bolt in the middle of the ring terminal to basically crush a single point into it.Then just take a bernzomatic, etc. and heat up the ring terminal to melt the solder and let cool...you should now have a very good crimp made, just give it a stout pull after it cools to confirm too</blockquote>

Top