Reply to thread

Message

<blockquote data-quote="Blackout67" data-source="post: 8903971" data-attributes="member: 683415">Sub would be the Earthquake Tremor series. They are rated for 300-400 watts rms IIRC. From what I see they have a very low FS compared to the typical 10 inch sub. Idk how accurate it is, but the one way excursion rating is 1.2 inches. The SLAPS M10 shows a one way excursion of 2 inchesAlso so I couldnt have a box with the 2 PRs on the side facing the trunk lid and one active on either side of that cabinet? They have to be on the same side? Idk if I would have the length to go with that. Even if its 2 10 inch PRs and 2 10 inch actives, thats gonna be like 44-46 inches in length. Are there any other good 10 inch subwoofers in the ~$200 range that are also efficient? I could make a single active 10 with 2 10inch PRs fit.I have a JP13 amp to play with and im not planning on doing a alt upgrade, just one big AGM and a big 3 kit so im looking for efficiency but regular ported boxes get a big too big when I model them. My JP13 does ~1300 watts RMS at 2 ohms with 90 percent efficiency</blockquote>

[QUOTE="Blackout67, post: 8903971, member: 683415"] Sub would be the Earthquake Tremor series. They are rated for 300-400 watts rms IIRC. From what I see they have a very low FS compared to the typical 10 inch sub. Idk how accurate it is, but the one way excursion rating is 1.2 inches. The SLAPS M10 shows a one way excursion of 2 inches Also so I couldnt have a box with the 2 PRs on the side facing the trunk lid and one active on either side of that cabinet? They have to be on the same side? Idk if I would have the length to go with that. Even if its 2 10 inch PRs and 2 10 inch actives, thats gonna be like 44-46 inches in length. Are there any other good 10 inch subwoofers in the ~$200 range that are also efficient? I could make a single active 10 with 2 10inch PRs fit. I have a JP13 amp to play with and im not planning on doing a alt upgrade, just one big AGM and a big 3 kit so im looking for efficiency but regular ported boxes get a big too big when I model them. My JP13 does ~1300 watts RMS at 2 ohms with 90 percent efficiency [/QUOTE]

Verification