Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
couple of questions: Ground loop and Wiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mrToester" data-source="post: 7355476" data-attributes="member: 631372"><p>Yeah, my line out converter is a MTX ReQ5. I have 6 channels RCA hooked up to that, going to my 2 amps. there the Speaker wires are now being fed to the same spot that i cut wires for the ReQ5. the wires are connected to the wire that was coming out of the stock HU(did this for less cuts in the lines).</p><p></p><p>Front doors has "Amp1" on the kicker IX 500.4. and the rear door and rear Deck speakers are on "Amp2" which is running series. the rear door are 2ohm and the rear deck are 4 ohms.</p><p></p><p>I will also do up the ground. i have to find a way to grind down to bare metal. What is best for this??</p></blockquote><p></p>
[QUOTE="mrToester, post: 7355476, member: 631372"] Yeah, my line out converter is a MTX ReQ5. I have 6 channels RCA hooked up to that, going to my 2 amps. there the Speaker wires are now being fed to the same spot that i cut wires for the ReQ5. the wires are connected to the wire that was coming out of the stock HU(did this for less cuts in the lines). Front doors has "Amp1" on the kicker IX 500.4. and the rear door and rear Deck speakers are on "Amp2" which is running series. the rear door are 2ohm and the rear deck are 4 ohms. I will also do up the ground. i have to find a way to grind down to bare metal. What is best for this?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
couple of questions: Ground loop and Wiring
Top
Menu
What's new
Forum list
