Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Could it be my hu pre out voltage?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="sounds_explicit" data-source="post: 8711873" data-attributes="member: 665284"><p>Ok I will.play a 1k hz tone and measure my voltage coming out of one of the bridged channel and see what it is. I only want to run about 100 watts to my door speakers. I have 4 Hertz centos pros rated at about 95 watts rms. So I would just play a test tone and set front and rear gain to voltage that would measure to square root of 100 watts at 2 ohms?( which is what they are wired to and amp stable at 2 ohms bridged, which the amo is bridged) I plan on adding maybe 2 more on each door for total of 8 if I can even run that many properly wattage wise. Would that be possible to run 8 4 ohm 95 rms speakers on the rockford power 600.4? And properly power them? Would I have to run them in series?</p></blockquote><p></p>
[QUOTE="sounds_explicit, post: 8711873, member: 665284"] Ok I will.play a 1k hz tone and measure my voltage coming out of one of the bridged channel and see what it is. I only want to run about 100 watts to my door speakers. I have 4 Hertz centos pros rated at about 95 watts rms. So I would just play a test tone and set front and rear gain to voltage that would measure to square root of 100 watts at 2 ohms?( which is what they are wired to and amp stable at 2 ohms bridged, which the amo is bridged) I plan on adding maybe 2 more on each door for total of 8 if I can even run that many properly wattage wise. Would that be possible to run 8 4 ohm 95 rms speakers on the rockford power 600.4? And properly power them? Would I have to run them in series? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Could it be my hu pre out voltage?
Top
Menu
Home
Refresh