Reply to thread

Message

<blockquote data-quote="Flipx99" data-source="post: 2550197" data-attributes="member: 562352">That DLS midrange I spoke about may fit. The mounting diameter is only a few inches (a little under 5&quot;). i couldn&#039;t find much outside of the aura whisper that may work and this dls.Here are some specs on that DLSSpeaker type : 75 mm (3&quot;) doped fabric with chamberPower handling capacity : 100 W RMS / 160 W maxImpedance : 4 ohmFs, resonant frequency : 280 HzVoice coil : 75 mm / 3&quot; Aluminium flat wire, 5 mmX-max : +- 0,5 mmFrequency range : 250 - 8000 HzSensitivity : 91 dB (1W/1m)Magnet size : 80 mm (3,15&quot;)Outer diameter : 120 mm (4,72&quot;)Installation depth : 35 mm ( 1,38&quot;)Mounting hole : 95 mm (3,74&quot;)I have an S-10 and have it worse than you as much of my door panel is curved and it is difficult as hell to mount a tweet without serious mods to the A-pillar. Keep this thread up as no one has jacked it up yet and has very good info.</blockquote>

[QUOTE="Flipx99, post: 2550197, member: 562352"] That DLS midrange I spoke about may fit. The mounting diameter is only a few inches (a little under 5"). i couldn't find much outside of the aura whisper that may work and this dls. Here are some specs on that DLS Speaker type : 75 mm (3") doped fabric with chamber Power handling capacity : 100 W RMS / 160 W max Impedance : 4 ohm Fs, resonant frequency : 280 Hz Voice coil : 75 mm / 3" Aluminium flat wire, 5 mm X-max : +- 0,5 mm Frequency range : 250 - 8000 Hz Sensitivity : 91 dB (1W/1m) Magnet size : 80 mm (3,15") Outer diameter : 120 mm (4,72") Installation depth : 35 mm ( 1,38") Mounting hole : 95 mm (3,74") I have an S-10 and have it worse than you as much of my door panel is curved and it is difficult as hell to mount a tweet without serious mods to the A-pillar. Keep this thread up as no one has jacked it up yet and has very good info. [/QUOTE]

Verification