Reply to thread

Message

<blockquote data-quote="miker" data-source="post: 3632314" data-attributes="member: 580956">F**K! Nothing is ****ing going right!................. The rear bolts on my seats have no ****ing clearance so it&#039;s impossible to stick a ratchet under there, and their is not enough room on either side of the bolt to use a wrench or channel locks.Then My floor didn&#039;t ****ing fit.... Well actually it fit perfectly, but The back of it was touching the sub, and I though that no good could come of that... So I had to cut sections out.... God this is just getting shittier by the minute... Not it&#039;s ****ing 9:15, and I&#039;m no where.... Wait no.. I have a box in the car, and grounds made!I still need to run all my speaker wire, get replacment screws for my amp, and find some way to get the dumb ****ing seat out... arghhhhhhhh. I have been out there for 2 hours, and didn&#039;t get shit done...Sorry for the vent... I just needed to say it... I know half the stuff is my fault, but it still makes me angry...</blockquote>

[QUOTE="miker, post: 3632314, member: 580956"] F**K! Nothing is ****ing going right!................. The rear bolts on my seats have no ****ing clearance so it's impossible to stick a ratchet under there, and their is not enough room on either side of the bolt to use a wrench or channel locks. Then My floor didn't ****ing fit.... Well actually it fit perfectly, but The back of it was touching the sub, and I though that no good could come of that... So I had to cut sections out.... God this is just getting shittier by the minute... Not it's ****ing 9:15, and I'm no where.... Wait no.. I have a box in the car, and grounds made! I still need to run all my speaker wire, get replacment screws for my amp, and find some way to get the dumb ****ing seat out... arghhhhhhhh. I have been out there for 2 hours, and didn't get shit done... Sorry for the vent... I just needed to say it... I know half the stuff is my fault, but it still makes me angry... [/QUOTE]

Verification