Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Comparing RMS ratings...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="natem33" data-source="post: 14633" data-attributes="member: 541071"><p>if you are hearing distortion at any volume then your Pyle will not last long at all. I know it's tempting to crank the gains up on the amp but keep them at 2/3 max, that is a safe level. A sub with a higher rms rating will not give you a dramatic improvement. The problem isn't so much with the sub, but with the quality of the signal being produced by the Jensen. If the Jensen is cranked up, then the sub will not receive a clean signal. A better amp will run the Pyle sub a little cleaner, but still beware of distortion/clipping.</p></blockquote><p></p>
[QUOTE="natem33, post: 14633, member: 541071"] if you are hearing distortion at any volume then your Pyle will not last long at all. I know it's tempting to crank the gains up on the amp but keep them at 2/3 max, that is a safe level. A sub with a higher rms rating will not give you a dramatic improvement. The problem isn't so much with the sub, but with the quality of the signal being produced by the Jensen. If the Jensen is cranked up, then the sub will not receive a clean signal. A better amp will run the Pyle sub a little cleaner, but still beware of distortion/clipping. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Comparing RMS ratings...
Top
Menu
What's new
Forum list