Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Check my math plz
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="dappa5" data-source="post: 8008471" data-attributes="member: 608565"><p>looks close enough ..... how are you getting 20.55 internal? typo? i figured it @ 20.5 in case it was and got 8.541xxxxxxxxxx</p><p></p><p>so based on that that port could be a hair shorter but if you keep it 11.25 ish it will be fine like 33.xxxx/34ish</p><p></p><p>of course this is all assuming a slot port with a top and bottom peice of mdf to make up the diff (from 20.5 internal and 18 int port )if you made it from top to bottom (i.e. 20.5x4 ) and make it 11.75 in length it will also put you right @ 35 hz</p></blockquote><p></p>
[QUOTE="dappa5, post: 8008471, member: 608565"] looks close enough ..... how are you getting 20.55 internal? typo? i figured it @ 20.5 in case it was and got 8.541xxxxxxxxxx so based on that that port could be a hair shorter but if you keep it 11.25 ish it will be fine like 33.xxxx/34ish of course this is all assuming a slot port with a top and bottom peice of mdf to make up the diff (from 20.5 internal and 18 int port )if you made it from top to bottom (i.e. 20.5x4 ) and make it 11.75 in length it will also put you right @ 35 hz [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Check my math plz
Top
Menu
Home
Refresh