Reply to thread

Message

<blockquote data-quote="sundownz" data-source="post: 3412284" data-attributes="member: 549523">Been playing w/ them a bit... unhooked one of them in my box (shared chamber, so one was kind of a PR)... anyhow, burped @ 55 Hz -- about where the box tune is. No numbers... this is just in my shop test box.67.7 volts47.1 amps---3188 watts @ 1.44 ohms (1/2 ohm nominal in parallel)One SAZ-3000D used for power. That is about all I can get w/ my Pyramid power supply and Wal-Mart Deep Cycles -- sold my test bench Kinetik or I could get a bit more like I did on the testing posting on my forum (a bit over 3200 watts w/ the Kinetik).Burped it about 5 times... then let it play on that wave over and over for about 12 seconds, no issues. I, of course, have heavily re-enforced these w/ epoxy.Sounds terrible with the spider inverting, but did not break.So... budget SPL it is... pretty useless daily w/ stock soft parts.</blockquote>

[QUOTE="sundownz, post: 3412284, member: 549523"] Been playing w/ them a bit... unhooked one of them in my box (shared chamber, so one was kind of a PR)... anyhow, burped @ 55 Hz -- about where the box tune is. No numbers... this is just in my shop test box. 67.7 volts 47.1 amps --- 3188 watts @ 1.44 ohms (1/2 ohm nominal in parallel) One SAZ-3000D used for power. That is about all I can get w/ my Pyramid power supply and Wal-Mart Deep Cycles -- sold my test bench Kinetik or I could get a bit more like I did on the testing posting on my forum (a bit over 3200 watts w/ the Kinetik). Burped it about 5 times... then let it play on that wave over and over for about 12 seconds, no issues. I, of course, have heavily re-enforced these w/ epoxy. Sounds terrible with the spider inverting, but did not break. So... budget SPL it is... pretty useless daily w/ stock soft parts. [/QUOTE]

Verification