Reply to thread

Message

<blockquote data-quote="Worlddre" data-source="post: 1308253" data-attributes="member: 556661"><p>if by side offsets you mean the sides of the box are sunken then its easy...just take a really sharp razor knife....once you have wrapped the rest of the box leave the sides blank....cut out towards you with the knife at each of the four corners of the box...now llay each corner down the way it is supposed to lay...take the knife again and cut from the corner to the middel of the box(do on each corner)..now glue all of this down and if you can get one use a pizza roller to tuck the corners in into the wood..now take the knife and cut around the the inside of the offsets...now you should have the offtet wrapped and the center blank....now take another sheet of carpet glue to the blank part take you pizza roller and tuck it into the side of the offsets and use the knife and cut around the corners as you did earlier and voila all done.....not sure how well i explained ill carpet one tomorrow and take pics for ya</p></blockquote><p></p>

[QUOTE="Worlddre, post: 1308253, member: 556661"] if by side offsets you mean the sides of the box are sunken then its easy...just take a really sharp razor knife....once you have wrapped the rest of the box leave the sides blank....cut out towards you with the knife at each of the four corners of the box...now llay each corner down the way it is supposed to lay...take the knife again and cut from the corner to the middel of the box(do on each corner)..now glue all of this down and if you can get one use a pizza roller to tuck the corners in into the wood..now take the knife and cut around the the inside of the offsets...now you should have the offtet wrapped and the center blank....now take another sheet of carpet glue to the blank part take you pizza roller and tuck it into the side of the offsets and use the knife and cut around the corners as you did earlier and voila all done.....not sure how well i explained ill carpet one tomorrow and take pics for ya [/QUOTE]

Verification