Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Car Battery sufficient for this setup?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="inVINCEable667" data-source="post: 2584065" data-attributes="member: 572498"><p>I am going to be using a KICKER SX1250.1 feeding my single 15" Solo-Baric 1200RMS power at 1 ohm. I am also going to be using a 2 Chanel Phoenix Gold R2.5:2 amp feeding my two components 75RMS as 2ohms...</p><p></p><p>I was planning to use 0 gauge wire from my car battery to a distribution block, then to my 5 Farad Capacitor, then power my two amps off of that. I am wondering if my car is capable of powering these two amps using only the car battery.</p><p></p><p>And if it matters I am using a Pioneer DEH-P7800MP headunit that is powering my rear speakers..</p><p></p><p>Thanks for any input/help/advice.</p></blockquote><p></p>
[QUOTE="inVINCEable667, post: 2584065, member: 572498"] I am going to be using a KICKER SX1250.1 feeding my single 15" Solo-Baric 1200RMS power at 1 ohm. I am also going to be using a 2 Chanel Phoenix Gold R2.5:2 amp feeding my two components 75RMS as 2ohms... I was planning to use 0 gauge wire from my car battery to a distribution block, then to my 5 Farad Capacitor, then power my two amps off of that. I am wondering if my car is capable of powering these two amps using only the car battery. And if it matters I am using a Pioneer DEH-P7800MP headunit that is powering my rear speakers.. Thanks for any input/help/advice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Car Battery sufficient for this setup?
Top
Menu
What's new
Forum list
