Reply to thread

Message

<blockquote data-quote="96civ" data-source="post: 4703785" data-attributes="member: 564776">Little update on the build. Hooked it up to my dad&#039;s Yamaha HTR-6030 receiver just to hear it a little. Sounds pretty good so far, but I have some tweaking to do. Everytime I try to wire two subs this way 1 / (8 + 8) + 1 / (8 + 8) = 8 ohm, which is 2 DVC 8 ohm subs to get an 8 ohm load, I run into a problem: one sub moves more than the other which I&#039;m assuming means one is getting more power than the other. This happened to me when I tried wiring my 2 Fi&#039;s in my car. Any ideas of what I did wrong? I fixed it by trial and error in the car, but I forget what happened. Oh well I&#039;ll pry just spend 30 minutes and figure it out tomorrow. I&#039;m also not sure if the 6.5&quot; TB is playing, I&#039;ll check voltage when music is playing tomorrow to see what&#039;s up.I&#039;ll have more pics later once I start rounding the edges, wood filling, etc...</blockquote>

[QUOTE="96civ, post: 4703785, member: 564776"] Little update on the build. Hooked it up to my dad's Yamaha HTR-6030 receiver just to hear it a little. Sounds pretty good so far, but I have some tweaking to do. Everytime I try to wire two subs this way 1 / (8 + 8) + 1 / (8 + 8) = 8 ohm, which is 2 DVC 8 ohm subs to get an 8 ohm load, I run into a problem: one sub moves more than the other which I'm assuming means one is getting more power than the other. This happened to me when I tried wiring my 2 Fi's in my car. Any ideas of what I did wrong? I fixed it by trial and error in the car, but I forget what happened. Oh well I'll pry just spend 30 minutes and figure it out tomorrow. I'm also not sure if the 6.5" TB is playing, I'll check voltage when music is playing tomorrow to see what's up. I'll have more pics later once I start rounding the edges, wood filling, etc... [/QUOTE]

Verification