Reply to thread

Message

<blockquote data-quote="Blackout67" data-source="post: 8894056" data-attributes="member: 683415">You shouldn&#039;t need to bridge it. So each side of your fronts are wired in parallel. That means each side is presenting a 2 ohm load to the channel it&#039;s connected to. Then the rears will see 4 ohms.The way you are wanting to wire up the speakers will not work in bridged mode. If you try to run all 6 speakers in bridged, you&#039;ll either have to wire it in parallel which will present a ohm load that your amp is not able to handle in bridge mode or&nbsp; You&#039;d have to wire the front driver to the rear driver speakers in series which would be a major pain in the *** to run the wire from the rears to the fronts and back to the amp to get a 6 ohm load. Your amp is only 4 ohm stable bridgedTldr: wire the front mids and tweeters in parallel for each side for a 2 ohm load on the front channels then just wire the rear ones normally for a 4 ohm load on the rear channels. There will be no issues and it&#039;s the easiest way to do it</blockquote>

[QUOTE="Blackout67, post: 8894056, member: 683415"] You shouldn't need to bridge it. So each side of your fronts are wired in parallel. That means each side is presenting a 2 ohm load to the channel it's connected to. Then the rears will see 4 ohms. The way you are wanting to wire up the speakers will not work in bridged mode. If you try to run all 6 speakers in bridged, you'll either have to wire it in parallel which will present a ohm load that your amp is not able to handle in bridge mode or You'd have to wire the front driver to the rear driver speakers in series which would be a major pain in the *** to run the wire from the rears to the fronts and back to the amp to get a 6 ohm load. Your amp is only 4 ohm stable bridged Tldr: wire the front mids and tweeters in parallel for each side for a 2 ohm load on the front channels then just wire the rear ones normally for a 4 ohm load on the rear channels. There will be no issues and it's the easiest way to do it [/QUOTE]

Verification