Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Bridging my amps wierd problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="cbrei1023" data-source="post: 5606932" data-attributes="member: 604816"><p>I have a TXA 3004 on my Alpine Type R components. It is bridged for 300WRMSx2@4ohm I am giving them about 120W. When music is playing sometimes the right side just goes out and then comes back in a few seconds or minutes later and I cant figure out why.</p><p></p><p>All grounds are good. I have my RCAs into channels 1 and 2 and the amp is on 2 channel mode. I think this is right when bridging the channels. I have the pos of channel 1 and neg of channel 2 connected and the pos of 3 and neg of 4 connected...</p><p></p><p>What am I doing wrong or where could the problem be. Thanks</p></blockquote><p></p>
[QUOTE="cbrei1023, post: 5606932, member: 604816"] I have a TXA 3004 on my Alpine Type R components. It is bridged for 300WRMSx2@4ohm I am giving them about 120W. When music is playing sometimes the right side just goes out and then comes back in a few seconds or minutes later and I cant figure out why. All grounds are good. I have my RCAs into channels 1 and 2 and the amp is on 2 channel mode. I think this is right when bridging the channels. I have the pos of channel 1 and neg of channel 2 connected and the pos of 3 and neg of 4 connected... What am I doing wrong or where could the problem be. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Bridging my amps wierd problem
Top
Menu
What's new
Forum list
