Reply to thread

Message: <blockquote data-quote="sam_b03" data-source="post: 7883828" data-attributes="member: 607518">The way I wired my 4 channel up was left speaker wired to the front channels +left and -right. Then  right  speaker to the rear channel +left and -right.  I set my gains as equal to one another. When bridging an amp they usually can't handle low  Ohm loads. This is why the specs always list Xwatts x 4 @ 4ohm; Xwatts @ 2Ohms (this number is usually double the 4ohm).  Then  Xwatts x 2 @ 4Ohms. (the bridged is usually around double the  2Ohm rating).You are not upping the wattage by reducing the Ohm load.  You are upping the wattage by powering 1 speaker off 2 channels from amp.</blockquote>

Top