Reply to thread

Message: <blockquote data-quote="c0smo kram3r" data-source="post: 5502917" data-attributes="member: 603841"><p>A buddy of mine has already purchased 2 new AQ2200d amps.  Now, he's going to buy 2 new AQ HC3 15's.  Would the copper get it done, or should he go up to aluminum?  My other question is about breaking them in.  He wants to wire the loads on the amps to 2ohm to begin w/ to break them in @ 1300RMS each.  Then bump up to 1ohm on each amp to get the full 2200watts.  Is this a good idea?  If so, should he go w/ Dual1 or Dual2?</p></blockquote><p></p>

Top